Prerequisites / Requirements
Access to WHM.
A domain to use for your nameservers.
At least two IP addresses for your nameservers.
Access to your domain registrar to register the nameservers.
Step-by-Step Instructions
1. Select Nameserver Software
In WHM:
Open Nameserver Selection.
Select Bind.
2. Open Basic Setup
Go to:
Server Configuration → Basic cPanel & WHM Setup
Scroll to the bottom of the page until you reach the Nameservers section.
You must configure at least two nameservers, unless you previously selected Disabled.
3. Configure Your Nameservers
Enter the names you want to use for your nameservers.
Nameservers should follow this format:
prefix.yourdomain.com
For example:
ns1.yourdomain.comns2.yourdomain.com
Keep the following in mind:
Use a unique name for each nameserver.
ns1 and ns2 are commonly used.
Choose names that are easy for your customers to recognize and enter manually.
4. Assign IP Addresses
Assign an IP address to each nameserver.
For best practice:
Use a different IP address for each nameserver.
Make sure the domain used for your nameservers has an account in WHM.
5. Register Your Nameservers with Your Registrar
After configuring the nameservers in WHM, you must register them with your domain registrar.
Important: Registering nameservers is not done in WHM or cPanel.
If your domain is registered with Miss Hosting, contact our support team for assistance.
Troubleshooting / FAQs
Can I use only one nameserver?
At least two nameservers should be configured unless you have specifically selected the disabled option.
Where do I register my nameservers?
Nameservers must be registered with your domain registrar, not in WHM or cPanel.
Summary / Next Steps
Your custom nameservers are now configured in WHM. After you register them with your domain registrar, they can be used for your domains and will become available across the internet.